Spare Knife Clamp for Controlled Angle Knife Sharpening System LP006

The Lansky Mulit-Angle Knife Clamp provides secure and exact blade positioning. This extruded aluminum knife handling clamp can hold almost any blade. The notched jaws provide secure and exact blade handling on almost all blades, including most narrow blades (such as tiny swiss army-type blades) 1/2″ wide and under.

Instructions

• Loosen the front red thumbscrew screw 2-3 turns.
• Tighten the back red thumb screw until it is approximately one full turn from being fully tightened.
• Loosen the front red thumbscrew of the knife clamp again to accommodate thickness of blade.
• Attach the clamp to the spine of the knife blade at the center of the blade.
• Approximately 1/2 inch of the blade should extend from the end of the clamp.
• Tighten the front screw again to hold the knife securely.
• Lock the blade in place by hand tightening the back red thumb screw on the clamp.