Soft-Grip Knife Clamp for Lansky Sharpening Systems RCLAMP

Lansky

The dual thumbscrew Soft-Grip Clamp was designed specifically for those looking for an easier to use clamp, that would also prevent scratching on coated or highly polished blades. Not for use on blades 1/2″ wide or less. Can hold almost any blade up to 7″ long.

For sharpening blades 1/2″ wide or less (such as tiny swiss army-type blades), use the Standard Knife Clamp.

Made in China.

Instructions
USING YOUR SOFT-GRIP KNIFE CLAMP

Loosen the front red thumbscrew screw 2-3 turns. Tighten the back red thumb screw until it is approximately one full turn from being fully tightened. Loosen the front red thumbscrew of the knife clamp again to accommodate thickness of blade. Attach the clamp to the spine of the knife blade at the center of the blade. Approximately ½ inch of the blade should extend from the end of the clamp. Tighten the front screw again to hold the knife securely. Lock the blade in place by hand tightening the back red thumb screw on the clamp.